Quote:
Originally Posted by
martiangurll 
Just tell me the secret of not nicking the surface of the shadow. Do you use the heat technique with a candle/lighter or the alcohol to dissolve the glue?
I use my straighteners - I just place a piece of paper over the plate so that I don't get melted plastic on them!
Here's what I do:
1) Pop out the e/s insert from the pot using a metal nail file
2) Place the insert on the straighteners for about a minute or so
3) Check that the plastic at the bottom is soft, turn over the insert so it's e/s down, and press the pan partially out using the nail file
4) Using the nail file, pry the pan off the plastic completely and leave it gluey side up
5) Pop the insert back into the e/s pot, minus the pan
6) Stick a magnet onto the pan and clean the sides of any glue (I just use some crappy face wipes)
7) Place the e/s pot onto the straighteners
8) Wait until the glue under the name sticker is melted, then slide the nail file under the sticker to peel it off, then stick it on the bottom of the pan
9) Ta da! Eyeshadow depotted :D